Dotworkz D3-TR-MVP Installationsanleitung PDF herunterladen (Seite 14)

Installing Camera Bracket

Axis 214 PTZ

1. Install the Axis 214 PTZ camera onto the

D2 Camera Bracket with (3) m3-.5 screws,

(3) m3 external lock washers, and (3) m3 1/8"

washer that are included.

2. The Axis 214 PTZ camera requires a 2.25"

spacing for optimal fit and operation. Use (1)

1.5" standoffs and (1) .75" standoffs that are

provided to create a 2.25" standoff. You will

need to create 4 of these with the included

hardware.

Required components (see component

checklist): Part # 1,3,5,12,14,15,& 16

3. The 2.25" standoffs will be inserted

on the upper portion of the D2.

1.5"

.75"

4. Now slide the camera bracket with

the camera into place to line up with 4

screws holes from the standoffs.

5. Use (4) #8-32 screws (Phillips head)

to secure the bracket into place.

Again, make sure the camera

bracket is facing the right

direction.

This edge nests in arch at front of D2

This edge of the bracket faces back of the D2 enclosure

Tip: Insert (2) #8-32 screws in the front two

standoffs to provide a guide to slide the

camera bracket into. The last two corner

holes should line up and be secured last.

Picture represents camera bracket orientation & how it is

secured. Don’t’ forget to mount your camera to the D2

camera bracket based on instructions.

Picture represents standoff location & orientation. Height

of standoffs will vary depending on camera used.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

Keine Kommentare

Dotworkz D3-TR-MVP Installationsanleitung Seite 14