Dotworkz D3-TR-MVP Installationsanleitung PDF herunterladen (Seite 22)

Installing Camera Bracket

Sony RZ30N

1. Install the Sony RZ30N camera onto the D2

Camera Bracket center hole with (1) .25"-20 3/

8" Long Bolt, (1) .25" Lock Washer, and (1) .25"

Washer that are included.

2. Use (1) m3-.5 ½” long screw in the second

corner hole to prevent the Sony RZ30N from

moving left and right. The screw will protrude

out from the bracket about ¼”. The Sony RZ30

should have a threaded hole that will align with

the second corner hole.

Required components (see component

checklist): Part # 1,2,3,6,7,8,12, & 14

3. The Sony RZ30N camera requires a

2.25" spacing for optimal fit and operation.

Use (1) 1.5" standoffs and (1) .75" standoffs

that are provided to create a 2.25" standoff.

You will need to create 4 of these with the

included hardware.

.75"

1.5"

5. Now slide the camera bracket with the

camera into place to line up with 4 screws

holes from the standoffs.

6. Use (4) #8-32 screws (Phillips head) to

secure the bracket into place.

Again, make sure the camera

bracket is facing the right direction.

This edge nests in arch at front of D2

This edge of the bracket faces back of the D2 enclosure

Tip: Insert (2) #8-32 screws in the front two

standoffs to provide a guide to slide the camera

bracket into. The last two corner holes should

line up and be secured last.

4. The 2.25" standoffs will be inserted on the

upper portion of the D2.

Picture represents standoff location & orientation.

Height of standoffs will vary depending on camera

used.

Picture represents camera bracket orientation & how it is secured.

Don’t’ forget to mount your camera to the D2 camera bracket based

on instructions.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Keine Kommentare

Dotworkz D3-TR-MVP Installationsanleitung Seite 22